What to make?

I am looking at build either the MPCNC or low rider. My question is accuracy and precession between the two. I current have a laser and make a lot of cutting boards and lake maps so precession is key to me. I want to move into inlay cutting boards and larger lake maps. I would love to do a full 4x8 build for future potential projects. But really I only need about 2x4 for most of the things I make. Anyone able to help lead me one way or another?

1 Like

A lowrider is plenty accurate enough for inlays. I have a LR3 now and do them. Not a problem. I also have it setup for 4x2 on it’s regular table for most things and a setup for 4x8 when I need it, but usually it’s on the 4x2.

1 Like

I used to have a Primo, then I built a LR3, which still had a few things lacking compared to the Primo. Now I have a LR4 and in my eyes nothing speaks for an MPCNC any more, with how great the LR4 is.

All of those boards were made with a LR3:

If you look at my current projects (www.hawiwe.de), you can see how great the LR4 performs. :smile:

3 Likes

I destroyed my mpcnc to build the lr4. The LR4 is magnificent.

The mpcnc is great if you do smaller things, but the open-ness of the lr4, I cannot say enough for it!

Also the rigidity improvements of the lr4 just make it a MUST build in my opinion, even if you make it small!

3 Likes

Thanks everyone the validates my thought process. To be honest I just fished printing all the LR4 parts last night. I was just hoping for validation before ordering the parts kit for it.

7 Likes

Welcome to the LR4 Crew!

P.s. buying plates saves a ton of time. Ryan sells them at a tremendous Value! Then you can build once and enjoy!

1 Like