FluidNC Eggbot

Software / Firmware Jackpot Board / FluidNC
94

Thanks

Are you using X for rotation?

Here’s my Z axis for the Jackpot V2:

  z: 
    steps_per_mm: 100
    max_rate_mm_per_min: 5000
    acceleration_mm_per_sec2: 100
    max_travel_mm: 5
    soft_limits: false
    homing: 
      cycle: 0
      allow_single_axis: true
      positive_direction: true
      mpos_mm: 0
      feed_mm_per_min: 100.000000
      seek_mm_per_min: 200.000000
      settle_ms: 500
      seek_scaler: 1.100000
      feed_scaler: 1.100000

    motor0: 
      rc_servo: 
        pwm_hz: 50
        output_pin: gpio.27
        min_pulse_us: 1000
        max_pulse_us: 2000
Eggbot build