CNC-cut table for LowRider v3 (parameterized, for cutting full sheets+)

[DougJoseph (Doug Joseph (design8studio))]

Looking good!

If you search the forum for this tag: parametric-table

… there is a design by Ryan that shows a suggestion for legs!

Matter of fact, here’s the direct link to it for you:

Parametric Table

Continuing down my table rabbit hole from an earlier idea drop, I did some learning today, tramming - #42 by vicious1 I have not built this table yet, so use at your own risk. [table] The key ideas here *Can be cut with a CNC, table saw, or straight edge guided circular saw. Use what you have! *If you use a CNC the alignment slots and holes can be used to speed up assembly. *I would make the top Surface taller than the rails by at least a few mm to be able to surface it several times. If …