Wiring diagram for skr board

[jeffeb3]

On upgrade path: LR2 -> LR3, Clarksburg, WV, USA

Also, just for a record here in my history, and that may be a help to someone else… LowRider 3 Dual End Stop board pins while using pre-configured firmware (“V1CNC_SkrPro_DualLR_2209-2.0.9.2”) for SKR Pro v1.2 — Dual End Stops for LowRider This is the pin configuration that finally worked for my end stops: End Stop Connected to X X min Y1 Y-min Z1 E2 Y2 E1 Z2 E0 And here is a graphic illustrating it: [BIGTREETECH-SKR-PRO-V1_05_PIN-OUT-ILLUSTRATION-END-STOPS]

This should help. I hope that diagram gets into the docs at some point. The skr and rambo have different names for the endstops, so it ends up being a lot of combinations of what to wire where.