Status on Lowrider 4

[bsmtdweller (Sam)]

I created a topic on how I calibrated my XY on my Bambu X1C, for anyone interested.

Bambu X1C XY Calibration

Disclaimer: Try this at your own risk. I originally goofed by missing a zero when inputing the correction, and my printhead slammed to the back. These settings are easy to reset back to default, but just make sure you don’t miss any digits So I went down a rabbit hole trying to figure out if I can calibrate my X1C. As of Oct 2024 you can’t calibrate the XZ/YZ, but you can calibrate the XY which I will describe how to do below. Bambu uses marlin for g-code, and there is a gcod…