LowRider Endstop Adjustment v1.zip (40.0 KB)
I did this fusion project up some time ago to calculate endstop offsets.
The sketch lines on the sides represent the belts, and use the Belt_Width parameter. I didn’t parameterize the sketch all that much though, because the rest of the parameters just assume that you commanded a square, and got a parallelogram with equal length sides. (This may not be exactly true, but is probably close enough.)
In the sketch, you enter the 2 diagonal measurements, and the calculated offset is on the lower right.
Edit: LOL, I knew that I’d put a topic out there… Square your Lowrider by adjusting endstops