Repeat V5 build

[MakerJim]

Ok this sort of brings it back full circle. I’ve been studying the Voron toolheads, and am liking the DragonBurner V8, which has really good modularity.

I’m thinking of building one up for the Repeat with an Orbiter extruder and a TZ V6 2.0 hotend.

After much thinking, it turned out I realized I’d seen something similar here in the forums…

None other than @probrwr build here:

SW VA V5 with a DragonBurner, DragonCutter and Filament sensors on the toolhead

Just starting up a new thread to cover the full build of the machine. This may take a little time as We leave on vacation to Mexico for a few days next week. The Plan: Build a V5. I will be using blind joints at the connections as I have a really good way to square the ends up (see my other build thread). I will probably add the panels at a later date when I get off my ass and finish my LR3. The impetus of this build is because I built a TradRack MMU unit and needed a few extra things on my t…

Mike- how are you liking that repeat build? Any gotchas or warnings about the DragonBurner on a Repeat?