Okay, I said I would release it. I have not tested the XY stepper mounts. I made some last minute changes. SO if you want to get started save those for last and I will print and test them next week. So Releasing it just to not go back on my work but not 10000% done yet.
Basic rundown.
*To change the size; you need to change the XYZ linear rail length. I tested it a few saves ago and it worked fine. Open and save the “parameters” file, then the rail/s you changed. Then open, update, and save the “coreXY V2” file, and then you can open and update the “MP3DP v4” file.
Sorry Fusion handles this sort of thing very poorly as far as I can tell.
X=Usable+100mm
Y=Usable +50mm
Z=Usable+50mm
*Hardware, linear rails all use M3x8 (plus the one stepper mount marked with an “8”.) M2.5x12 for the endstops, M3x10mm for the rest that is not M5x30 &nuts.
*If you are using the hemera the previous fan and BL touch mount are fitting perfect. Any other extruder, there is plenty of room.
*Firmware is not in the builder yet…I was a dumb dumb and deleted it off my desktop so I need to rework it.
*I have a filament tube holder and LCD holder coming soon. Going to play with the board location to optimize this a bit.