Plasma cutter MPCNC (Norway)

[jeyeager (Jason Yeager)]

@johtus

i have not found any good ways to export from fusion on hte free version.

I bought a plugin for Fusion called MapBoards Pro that greatly simplifies the DXF export process. I gave some details in this thread.

Slant Board

A week ago, my wife sent me a couple links asking if I could make one of these. Now that I have a LowRider, this was much easier and turned it around in a week, which is dramatically shorter than normal. Still needs a finish applied and some grip tape, but it’s otherwise complete. There were some angles that I cut on my table saw. [20240204_165334] I didn’t even know what it was. Apparently, it’s for stretching and helpful for foot pain, which makes sense since she’s a runner. Here’s a v…

@johtus

fusion is getting more and more limited on the free version so I am exploring my options. Is there any good free alternatives to fusion or should i just pay up?

I’ve been investigating FreeCAD lately. There are 1.0 release candidates now. It’s definitely different than Fusion though.