V1 Engineering Forum

Mpcnc fusion360 config

Software / Firmware Fusion360

staffordj (Stafford) April 10, 2025, 8:13pm 2

Check this topic:

Fusion 360 Post Processor (v2.1) is Available Fusion360

Release V2.1 of the Flyfisher604 F360 post processor is available. Release History ----- Github tag: v2.1 ----- Enhancement: Custom gcode for coolant channels can be defined ----- Github tag: v2.0.1 ----- Bugfix: Undefined variable used for Z height during toolchange, garbage output ----- Github tag: v2 ----- Numerous bugfixes Coolant channels reworked; allows for channels A and B to be enabled at the same time; allows a coolant type to be defined for a laser; coolant properties are un…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled