As promised, here’s the revised Tripod tramming tool.
The 1/4" centre hole has zero tolerance, so if your print is a tiny bit off you’ll need to hand ream a 1/4" bit through it - which of course will carry great risk of sending it microscopically out of square.
The outer tripod feed are M3 and I would like to see a washer top and bottom.
Once you get more or less level - rotate the thing and use one leg only for the final detail to counter any inaccuracy.
I’ll definitely print one, but not this week, possibly next - if you do and it works, post a pic please!
Tramming Guide - TramNinja.stl.zip (225.5 KB)
And now in 8mm (8.1 diameter hole)
Tramming Guide_8mm - TramNinja.stl.zip (310.6 KB)