Lowrider2 in Wyoming

[droesch (Dan Roesch)]

This is what I used for cable management.

X Axis Wires are determined to get run over

My X Axis wires are determined to get run over by the router. One time they got successful and I had to jump to pull the plug. The wire wrap and the dupont connectors melted onto the router bit + collet and got real nice and wrapped up. A few other times I’ve had enough time to yank them back into a good spot well away from the plate. So… What are some routing strategies for the X-Axis wires? Currently I try to run them up from the motor and through a couple of rings attached to my vacuum hose.…