I’m considering running a strip of hardboard down the one side of my table to give my wheels something flat to run on (I have a groove I made in my table where the V2 wheels ran in). Will it cause problems to raise the wheels like this by 1/8” assuming the pipe brackets are also raised this much?

No, I’ve had every LowRider on runners. :slightly_smiling_face:

[image] No problem… I even think it makes the setup a lot easier [image] [FR] TS-Rider - LR3-LR4 conversion Your Builds So… bought new belts, had a good sleep, and back at it… The table is still a bit rough but I removed the trim and the old spoilboard and c…

Lowrider V4 can I have the wheels run on a raised surface

LowRider CNC Advice

Fabien (Fabien) May 16, 2026, 6:46pm 3

No problem… I even think it makes the setup a lot easier