Ok, this is getting to be a little frustrating.
I’m trying to cut a simple slot 5mm wide 6mm deep (I think), but it is not working.
there is some form of movement in the X axis and I cant figure out where.
the slot is being cut with two step downs, roughing pass and finishing pass at 600mm/min.
beginning end of the slot
it is wider and there is a visible ledge.
middle of cut
Less than 5mm
ledge is gone
Near end of cut
Less than 5mm
I used a pen to draw a long rectangular box first in one direction and then the same box in the opposite direction and it traveled line for line.
So what could be causing the drift when cutting?