A little over a month ago, I started some experimentation with an Elecrow 7" display with LVGL and my new friend Claude. It went way better than expected and this is the result as version 1.0.0. [splash-screen] [machine-selection] [sd-file-progress] [control-actions] [control-jog] [control-…

That’s not really practical. It would require downloading the gcode file and parsing the entire thing to find max and min X and Y values. That type of thing almost requires a sender.

Lightburn has a framing option to send

I put the battery positive to the center contact on the switch and the on contact to the board. I wired a charging port to the other side of the switch so I could charge the board when it is off. I had to drill a hole for the charge port. But it all fits and no extra components are needed. This way …

[image] jeyeager: CrowPanel-Advance-7-HMI-ESP32-S3-AI-Powered-IPS-Touch-Screen-800x480/3D file at master · Elecrow-RD/CrowPanel-Advance-7-HMI-ESP32-S3-AI-Powered-IPS-Touch-Screen-800x480 Hi, thanks für the Link I printed it and it looks amazing. Would you be able to send the file without the …

@jeyeager Here’s the pull request for the battery meter using the board I mentioned: Add Battery Meter Support by anant-singh · Pull Request #46 · jeyeager65/FluidTouch · GitHub . There are unfortunately multiple issues with this approach as well. When you plug it into charging it takes a while b…

[image] VIPer23: Would you be able to send the file without the antenna? Are you talking about my 3d printed case? [image] Jason Yeager: Here’s the current version of the case. Everything is fitting well for me. This only works with the Advance version of the display. Here are .3mf file…

[image] Anant Singh: Here’s the pull request for the battery meter using the board I mentioned: Ok, when I get a chance, I’ll order one of those battery meters and see how it works. For the simple voltage divider, I removed the cap and it still didn’t charge long. I need to try with 100k re…

Also, thanks to anyone using my affiliate links. I’m by no means getting rich off this but I just got my first $25 from it last week. It should come a bit quicker now since there’s about $60 pending but it takes awhile until it gets approved and processed. Some (not many) of them get denied like …

Hi Jason, Thanks a lot for the case. You are amazing with your contribution on this. I broke also the pin on the Boot button, hope this works now with your solution as well. Would you be able to take a look on an other problem that I have at the moment? I would appreciate your help on this a lot. …

Ooh. Goodies in the mail. [20260420_141432] [20260420_144923]

FluidTouch - Wireless FluidNC Pendant

Software / Firmware Jackpot Board / FluidNC

jeyeager (Jason Yeager) April 20, 2026, 12:53am 431

Are you talking about my 3d printed case?

And the buttons if you have the v1.4 display.