We might be getting enough snow tomorrow where I would need/want my snowblower. So, that was motivation to finish getting that ready. This means I had my propane heater going in my garage which meant it was warm enough for me to play with LEDs some more.
It’s a little hard to see but it tracks the position fairly well. It’s a bit off at high feedrates. Not sure if I want to play with the reporting rate or offset based on feedrate. I do plan on changing the config for the position width to be number of LEDs instead of mm.
That’s about as far as I plan on going with this for now. At least until I talk my wife into letting me make that wall mounted pen plotter and put it in the house. That’s a work in progress.