@DougJoseph Thank you for the design. I’ve printed a pair of enclosures and was plodding along slowly planning to build them up. I had snagged two of the M5Dials from the DigiKey link I had posted above.
I’ve decided to get the pair ready to take to RMRRF as was being discussed in a thread shown below.
A question- this pendant enclosure is awesome, but would be even more so if instead of a cable clamp there was a keystone opening so that a standard keystone ethernet jack could be used as the basis of the wiring. Any chance of a collaboration to make that happen?
A further side question- did you ever find a project to lay out a simple PCB? A carrier that had provisions to complete a turnkey pendant would be pretty simple- and pretty useful.