$79 laser engraver on Amazon... any good?

[Michael_Melancon (Mike M)]

@Roy_Johnson

Is there a way to replace the main board in these? If so, is it plug n play per say?

I don’t know about the OEM board, but this thread might be of interest to you…

Jackpot board install on JL1 laser

Starting a thread to document my work to put the Jackpot onto a JL1 laser. This will be another typically slow build log for me. Hopefully less slow than my stalled before seriously underway repeat printer log. Here’s the JL1 on my too small work surface I’m using at the moment: [image] That JL1 was a $75 purchase that our own @dkj4linux pointed out to us in these very forums. How cool of him to tip us off about really affordable hardware like that. I use Lightburn to drive it from a wind…