Yellow Machine

[jeyeager (Jason Yeager)]

There is also this LR4 parametric table.

Torsion LR4 table generator

While cutting cabinets I’m having a few problems related to my hacky table. Holding tabs sometimes are cut into the spoil board, not parts, which can cause chatter and inaccurate dimensions as the parts move a bit during the finishing pass. I also made the thing a bit too small, and it can’t actually cut up a full sheet, so I’m doing lots of shifting around to make cuts. Annoying! I was traveling again this week and used a flight delay to write up another cut generator, this time for a torsion…