Wiring diagram for skr board

[DougJoseph (Doug Joseph (design8studio))]

@Christian_D

Does from the power supply come + and - to power and motors?

As shown on this photo in my post:

On upgrade path: LR2 -> LR3, Clarksburg, WV, USA

Also, just for a record here in my history, and that may be a help to someone else… LowRider 3 Dual End Stop board pins while using pre-configured firmware (“V1CNC_SkrPro_DualLR_2209-2.0.9.2”) for SKR Pro v1.2 — Dual End Stops for LowRider This is the pin configuration that finally worked for my end stops: End Stop Connected to X X min Y1 Y-min Z1 E2 Y2 E1 Z2 E0 And here is a graphic illustrating it: [BIGTREETECH-SKR-PRO-V1_05_PIN-OUT-ILLUSTRATION-END-STOPS]

There needs to be power for the board itself, as well as power for the motors.

The board’s power is listed here as “Power 12v/24v” and the power for the motors is listed as “Moto Power.”