Whuch way should the z go when you press the Z+ button

Mostly Printed CNC - MPCNC Troubleshooting
1

Im sure its documented somewhere, but i cant find it. If you hit z+ does it go up and z- to go down? Im dumb. And tired.

But it works!!! Well, other than not being sure if im going the right way in Z.

1 Like
2

The MPCNC uses a right hand coordinate system.

X+ goes to your right
Y+ goes away from you
Z+ goes up from the table

There should be a place that you can stand where all this is true (or a wall where you could place a camera…

2 Likes
3

Sweet, that answers my question. I can home x and y and the z goes up like 10mm before homing, so i think im good.

Thanks so very much