Upgrade to JP 3 for Primo or LR4?

Software / Firmware Jackpot Board / FluidNC
1

I would like to upgrade my Primo which has been sitting idle as I built a LR4 with a JP1. I’d like to try a laser but not sure if I can easily vent as it’s in a finished basement.

Anyway I want to buy a JP3 but I really am leaning toward swapping my LR4 controller from the JP1 to the new JP3 and put the JP1 into the Primo.

I realize there is not a major difference but my LR4 is my go to machine especially since getting MillMage. Just looking for some feedback??

2

The JP1 will run a laser well. If you want another Jackpot the 2 will save you some money,.just use it on the non-laasr build.

3

Thanks already ordered a JP3 and forgot the power supply so ordered that too​:+1:

Not sure if the power supply went through I’ll check.