Hello, I am looking to build a Lowrider 3, and have printed most of the parts. I wondered if there are any publicly known details on the Lowrider 4. I am trying to decide if it’s better to pull the trigger on the hardware kit now and finish the build before I go back to school or sit on it.

TL; DR: Low Rider 4 is out and it’s great. I’m closing this post. If you have a question about the new Low Rider, I suggest making a new post (the circle with a + in it in the bottom right of the forum). I suggest choosing Advice category or the Hardware Development category. If you need this reope…

Bambu prints can only currently be XY skew calibrated, XZ an YZ are not enabled yet. They are decently square on arrival but no they are not as close as they can be. Hopefully bambu adds Z skew soon.

That’s an interesting table design. No spoil board or has he engraved his spoil board?

Reading this thread is giving me flashbacks to dealing with junkies looking for a hit :laugh:

I remember a post or video where Ryan laser engraved a design on a spoil board. Or I feel like I remember that any way :rofl:

[image] Nathan Doty: has he engraved his spoil board? He laser engraved his with a fancy ass lace pattern he made. It is cool! way cooler than mine was lol… [image] JJ’s Full Sheet LR3 Rebuild Your Builds And it’s finished… [IMG_4981] [IMG_4980] [IMG_4979] …

[image] Nathan Doty: has he engraved his spoil board? post here [image] Parametric Table Updates and News [PXL_20231210_011136792] [PXL_20231210_011057869] [PXL_20231210_011212118] For sure, like a Henna, since it will not last long. I will do it again, though…

[image] Ryan: Bambu prints can only currently be XY skew calibrated, XZ an YZ are not enabled yet. I was looking at calibration options for my Bambu P1S today. Kind of stumbled on the same info. Do you for see this being a problem for the LR4? I’ll gladly print a calibration but if I can’t ch…

[image] Zach: I’ll gladly print a calibration but if I can’t change anything… Only way you will know if its a problem or not. It will let us know how far off it is, so that’s not a bad thing

Not familiar with these parts yet, are there certain things I can start sourcing now without any info on LR4 that’ll be ubiquitous to any CnC or LR in general? Otherwise I’ll just keep making sure my 3D printers work :slight_smile:

[image] Jonathan Jones: Only way you will know if its a problem or not. It will let us know how far off it is, so that’s not a bad thing Very very good point!

Status on Lowrider 4

LowRider CNC Advice

Michael_Melancon (Mike M) October 6, 2024, 4:31pm 535

post here