Thoughts on optimal way to install final Strut plates?
Noticed https://docs.v1e.com/lowrider/#disassembly is pending details.
Personally tried the following, but guessing there’s better way(s)…
- Slide Core to Min side (left)
- Propped up Max side of Beam with Duct Tape and 3M Post-It pads
- Fully unscrew X Belt tensioner.
- Remove XZ-YZ Max assembly
- Remove Max brace
- Slide Core off right end of Beam
- Mount and fasten Front and Bottom Struts to Beam
- Slice Core back on
- Reattach Max Brace checking M5 Nylock Nut for X Belt Tensioner is still in the Max brace
- Reattach XZ-YZ Max assembly
- Reattach X Belt Tensioner
100x clip vaguely following the above… https://zoomtube.com/@azab2c/make/v1e-lr4?v=8_0&t=25_23_43&r=100