I am getting very excited already.
2 Likes
I am with jonathon. Wish i could go!
Dont think i will even be able to make it to mrrf!
2 Likes
This will be in my car. Itās going to a friend whoās going to be at the show. I havenāt built though table for it yet as thatās going to be up to my friend who will be using it.
5 Likes
Black and brown, I like it. Seems more sophisticated!
12 days to setup day! SOOOO Closeā¦ (iām not ready)
4 Likes
Iām not ready, but I really want to be!!
3 Likes
Wish that i could go! mrrf was so fun. Enjoy all! Think i need a new job!
1 Like
I almost forgot. I am looking to get a nice smooth surface to draw on 38" wide or so, table length 24"-30" long. For the Lowrider. If any of you locals have something I can use some tape on that would be awesome. Otherwise I will just grab something at the hardware store when I get there, no worries.
38"x24-30"?
Did we use a piece of melamine from my garage last time? I remember thinking of bringing it, but I donāt remember what size it is.
Yeah, I donāt remember what we did with it though. If you still have it, that would be awesome. If not I can get one. I am coming in a bit early.
Tempted to come last minute. 1 hour drive from the DEN airport. That is like half the length of the flight from Southern CA
3 Likes
Ohhhhhhhh, Obviously I say do it.
1 Like
Iāll give you some stickers, a poster, something printed, I bet I can even get a beverage of your choosing.
4 Likes
Rubber Duckies, what about the Rubber Duckies? Iāve run out, my kid distributed them to friends and school, including the bewildered teachers 
EDIT: Found 5, am having to hide them from the kid. Will use to accessorize my next build.
1 Like
If I have room I will bring a lot, like enough, 
I should have used those as packing ducks for the LRā¦
4 Likes
See everyone this weekend. Itās only a 45 min drive for me
6 Likes
Sorry. Just saw this. Iāll check on a few minutes. I can probably handle this.
Stay tuned.
A couple details that Iāve been slow to ask about.
- I assume I should bring the Primo again?
Of so then
2. What is the schedule/ plan for setup?
I can be there pretty much any time, but would like to have some idea when.
We are SO looking forward to this.
2 Likes
Yes please!!
Friday any time between noon and 7, same table, or you can get in anytime after 8am Saturday. Whatever day you prefer.
1 Like
Ok. There are a number of options, but, the simplest would be one of these two.
A. 30" x 60" baltic birch plywood (3/4") with a formica surface on one side
B. 27" x 60" workbench top, 1.5".thick. Butcher block construction.
If absolutely needed, I could cut A to be about 40" long.
You can use as much tape as you want on either.
I have a selection of other sheet goods, including some MDF, which could also work, but it doesnāt have any melamine. I could probably cut it to 40" x 30" if size is critical.
Transport of 1 or more is trivial, of course.
1 Like