Repeat machining - homing & orientation?

[breese (Robert Gene Reese)]

You might want to look at this.

Fluidnc - Work Coordinate System (WSC) and uses

While getting setup to start a new project, I thought it would be a good time to get into Fluidnc and using Work Coordinate System (WSC). Fusion requires the part to be duplicated on the build page and then there are a number of steps required to make it know what is what and where they are located. Fusion Free version does not allow you to Post-Process WCS work. With a little effort and thinking, it is easy to setup a single gcode to make as many of the same part as long as you have the spac…