my ramps is setup and works fine controlling the xyz motors with marlin on my 2560 mega board. .when i change the software to grbl/mega i can connect ok but i can’t jog the motors.
Has anyone ran into this with grbl/mega and ramps board.
1 Like
Hi Scott welcome in.
I think we need some more details. What software are you changing? GRBL/mega should not be an option. For the ramps board you are looking for “Marlin”.
You can run grbl/mega on your RAMPS hardware but that’s not a combination that’s ever been supported by folks on this forum. You’re welcome to try and blaze your own trail, but you probably won’t find a lot of folks here with experience on this specific challenge who are able to guide you.
2 Likes