Power supply location for LR3 CNC

[azab2c (Kyle Reese)]

@jeffeb3

I put it under the table and I have a power box on the front with a switch.

Jeffeb3 Low Rider V3 Build Thread

[PXL_20220415_152830238] I built a nice little power box for it. This area was previously taken up by the LR1 parts. But it is free to use now that the gantry is all on the table. The right side is a commercial 120VAC power strip. I will plug the router in there and it will be my estop as well. This has a 10 foot cord and reaches the wall and then some. I don’t plan on hooking the dust collection to this. But I bet it would be fine. I have a bunch of extra ports for the air compressor and the…

Jeffeb3 Low Rider V3 Build Thread

That toggle switch is actually pretty deep, with the spade connectors sticking out the back. So it is just slightly proud. I could add some trim if I cared. I didn’t post a shot of it on. Oops. [PXL_20220415_163706038] I mostly like that I can turn off power to the skr without killing the pi. I am just sitting here testing the that the pi goes on before I reinstall the skr board over it. I also have edited your step file to embiggen it. I think it is going to be the “final” one.