Pebble's Low Rider 3 Full Sheet Build

[Pebble]

So I found another forum post that seems to explain my issue. I don’t quite understand what is going on but it has something to do with the G54 creating an offset and the machine sometime using that for coordinates. The correct fix seems to be to send a G10 L2 P0 X0 Y0 to reset things back to 0. I also added in Z0 to get everything zeroed out. My G54 was previously [G54:610.000,300.000,-68.185]. I’ve reset things and I’ll see what happens with it when I have more time.

FluidNC WebUI

These kind of issues bug me, so I have been doing some reading on work coordinates and I think I can explain this. There is always a current work coordinate set and it is usually G54. You can check this by entering command $G This shows all of the modes that are set. You can check what the workspace coordinates are by entering command $#. You can change a work coordinate using G10. In this case I used G10 L2 P0 X0 Y0. P0 is the current work coordinates, P1-P6 is G54-G59. In this screenshot…