Parametric Table

[Unklegwar (Eric)]

I’ve modified the OnShape project for half-lap joinery and some other ideas I’m playing with. If you have a tablesaw and a router, this might save you lots of cutting and lots of screws.

I’m still figuring out the forum tools, so, bear with.

Another LR4 Table

I have been mucking around with the Parametric Table(s) for my own preference on how to build a torsion box/table with what I have in my shop. I wanted to use half-lap joinery for the torsion ribs, instead of all those screws and little pieces, and I have the capacity to cut my own parts, so don’t have to resort to MDF moldings. My gut says slicing up a 4x8 sheet of 9mm or 12mm MDF will be cheaper. My plan is to rip all of those ribs, edges, rails, etc on my Sawstop, and then set up my router …