I’ve done these types of lettering a lot over the past few years but this is the first time I’ve ever seen this sort of issue. Here’s my lettering in EstlCAM: [2022-07-30_12h25_31] But when I open the Gcode in Repetier Host I get this as a result: [2022-07-30_12h25_44] The other cuts I am mak…

Odd Gcode result in Repetier Host

azab2c (Aza B2C) July 30, 2022, 7:14pm 7

As a temporary workaround, did/can you disable Arc G2/G3 in Estlcam?

Noticed @jeffeb3 recently reached out to Repetier folks, referencing this topic…

1 Like