And I do not know what erase does, never tried it.
If I have an issue I re-flash, make sure Archim is selected in the boards menu and you do NOT have u8glib installed.
There are a bunch of these out there now and I have not had any other issues. If it continues for you I will set mine up again and double check. At worst it is just a LCD timing issue. I think I have a know timing issue LCD to test with now.
Troubleshooting leads me to beleive its power related. Using a phone charger to supply additional power through the usb connection leads to stable operation. Next to test it with the motors and stops connected.
No dice. It doesn’t matter how many times you restart it, it still locks up (if you’re lucky enough to even make it to the main page.) But the moment you plug in a second power source, it works fine. I was able to get everything set up and draw the crown. The dual end-stops work great, the only hiccup was that the z was inverted.
Not sure if the board is faulty, or if there would be something in the firmware that might cause this behavior?
Router should be here Tuesday! (Wife wanted to start cutting some projects sooner rather than later, so I’ll have to re-do all my wiring for the plasma cutter sometime in the future.)
Some update pictures:
Put some wheels on with levelers.
12.8 no load coming out of the supply, 12.8 to the power block on the board (with or without the USB connected). 12.4 at the block when running the steppers(with the USB power connected - it freezes when the USB is disconnected)
Okay I am working on this now with Jason from ultimachine. The firmware I have up as of last night works better but without usb still blanks eventually. My old tagged version works fine so something has changed in the firmware. Getting there.
Awesome, thanks for the update! Jason emailed me last night and I linked him to the Github page for the firmware. It’s good to know that its reproducible and not just my board!
Rad Build! The wire braid sheath is intense man, major shielding…I think I just got a reality check on my secret little desire to do a plasma table. keep up the awesome work!
It’s probably overkill since I used shielded wire as well, but it adds some protection to the wires which is a nice bonus.
I forgot I had some ferrite beads, so I clipped one onto each if the short exposed sections of the steppers. Again, overkill. But I had them, so why not?!
I need to finish wiring for the outlet relay, and the torch relay. I need to sit down and read how to trigger them with the gcode, and the wiring for the Archim1.