Need help wiring up a SKR 1.4 Turbo to LowRider X-Post

[lagnajeet (Lagnajeet Pradhan)]

I posted this on the SKR section as I am not sure where you ask. But I am cross-posting it here

Need help wiring up a SKR 1.4 Turbo to LowRider

Hi All , The forums are really helpful and filled with a lot of information but after looking at it for past 2 to 3 days I am very confused regarding how to wire up a SKR 1.4 Turbo board with 2099 stepper driver to a lowrider V2 (I doubt if it matter if its V2 or V3). I have described my issue below and my interpretation for possible solution so far. 1. Issue I want to connect the X stepper , two Y steppers and two Z- steppers separately to all the five stepper ports in SKR 1.4 Turbo Possib…

Basically I just need to know if my understanding of hooking up the stepper, endstops and configuring and installing the firmware is correct.

Thanks in advance