NancyFräser - A new LR3 in Heidelberg, Germany

[jeyeager (Jason Yeager)]

I ran into the same issue. Ended up replacing one of the printed parts that meet up with the XZ plate.

Gantry Squaring Help

I’m a newbie in the middle of an LR3 build. After adding the Y rail, I noticed that the gantry was not even with the edge of my table. It’s far enough that if I flex it to compensate, it jumps off the Y rail. I purchased the whole kit from the store including the printed parts. I made sure all of the affected bolts/screws were tight (but not too tight) and parts did not have gaps. So, that’s wheel brackets to YZ plate, YZ plate to linear rails, linear rails to XZ plate, XZ plate to rail bra…