Has anyone had problems with the sizing transferring properly from carbide create to estlcam? I have my grid set up in carbide as 1” and set my stock as 24”x24” and in estlcam I have the grid set up as 25.4mm to equal an inch but when I transfer the document over from carbide it’s bigger than what the work piece represents in estlcam.
This board is $45 so I would like to maximize every square inch.
1 Like
How far off is it?
Does changing ESTLcam to inches instead of millimeters (before import) help?
Well I counted the blocks that supposed to be equal to 1” and it’s about a block and a half or so to big. I haven’t tried cause I worry about screwing something up lol.
1 Like
