Makerbase MKS Sbase

[remon_v (Ramon)]

It has DRV8825 drivers.
Is there a good general configure tutorial for Marlin?
I’m new to CNC or 3D printing, so I have no clue.

I’ve found a thread about the MKS Sbase with Smoothieware:

MKS SBASE V1.3 Dual Endstop Question [SOLVED]

That did the trick. homes X and Y now without an issue. Thx.

And 1 with Marlin:

MKS SBASE V1.3 Dual Endstop Question [SOLVED]

You may need to reverse the state of the endstops in the Configuration.h to false, re-compile, and re-flash. I have 3 wire endstops with LEDs. // Mechanical endstop with COM to ground and NC to Signal uses “false” here (most common setup). #define X_MIN_ENDSTOP_INVERTING true // set to true to invert the logic of the endstop. #define Y_MIN_ENDSTOP_INVERTING true // set to true to invert the logic of the endstop. #define Z_MIN_ENDSTOP_INVERTING true // set to true to invert the logic of the…