Hello I have been CNC’ing for about 18 months now using a 3018 pro with Grbl controller. I use Carveco Maker to produce my builds and the Gcode and send to the 3018 via UGS. This works really well as i like Carveco and UGS lets me override feeds and speeds if i need to during a process. I have how…

Thanks guys for your responses so far. At the same time as posting on the forum I sent a request to Carvoco asking if they had plans for a Marlin Post processor and it turns out they have one. @Tokoloshe this may be the same one as you’ve posted. However they provided two versions and some further …

LR3 and Carveco - SKR Pro or GRBL

Software / Firmware

Tokoloshe (Philipp) February 28, 2023, 1:45pm 4

Here is the post processor:

Here is a discussion: