LowRider 3 - Plasma Build "On a Budget" - Clarksburg, WV

[DougJoseph (Doug Joseph (design8studio))]

@kd2018

link to the latest pp that you’re using? And a sample output

Knowing that it was a bit hard to locate, and also knowing I would want to revisit it again, I posted it here in my own build thread:

Choice of two (2) PlasmaC (LinuxCNC) Post Processors for Fusion 360

Here are two I have found so far … both of which successfully produce code (which is as of yet untested as far as cutting): 1. PlasmaC (LinuxCNC) Post Processor for Fusion 360 dated March 2, 2020 This one seems like it might be more advanced than the second one below. It employs three different means for increasing cut quality on small circles. One of the three involves slowing the cut speed. I tried it on posting (processing a job) it works (produces Gcode). I don’t yet have my plasma cutte…

…It’s the first in that post, dated March 2, 2020.

As for sample output of it, attached is an actual posted file:

1001 - made with “PlasmaC-Plasmac” PP.ngc.zip (343.7 KB)