Thanks for the tip! I’d been thinking about that as I was “playing”. I modified Ryan’s crown to play with papers and cardstocks. I had to go down to 25% feedrate (on the LCD) to get it to cut through the 100lb cover weight stock. I wondered if it might have cut through better/faster if it wasn’t sitting on a solid surface (cardboard). 50% federates almost went through but not quite.
The laser turned back on (and turned off) partway through the z clearance moves - which I know I didn’t need…so I removed them from the attached. In case others want to play with the file. Note I haven’t test cut this but at these rates I was able to go through standard copier paper at 100% speeds.
LaserCrown.gcode (80.9 KB)