This probably sounds goofy but I have searched and haven’t found it. I’m hoping someone wouldn’t mind writing out their workflow for using the Jackpot? I’m getting ready to build an LR3. I’ve had my Primo for a long time but I had a rambo board so it was basically like 3d printing as far as workfl…

[image] Zach: Do you plug a usb cable in and go to a specific address in a browser? Is it wireless? Is it an app? The Jackpot board as you get it will have the FluidNC firmware installed, and will broadcast a WiFi Access Point with the SSID FluidNC, Pass:12345678. Connect to that and load th…

Jackpot Workflow

Software / Firmware Jackpot Board / FluidNC

staffordj (Stafford) October 19, 2023, 7:25pm 3

I asked a similar question here.