Jackpot 3 no Endstop LED's?

Software / Firmware Jackpot Board / FluidNC
1

I just upgraded to a Jackpot3 after being away for years. I remember the state of documentation back then and being “new again” I see the same challenges exist.

Coming from an SKR with Marlin and now on GRBL, how do I check the state of end stops so I don’t blow through limits at the first homing?

$limits

Send ! to exit

Homing Axes :             

Limit Axes :             

  PosLimitPins NegLimitPins Probe Toolsetter

Ryan let me know if there is a good way to submit edits to documentation.

2

Hi, welcome back.

$Limits type that in the webui terminal.

3

I don’t understand how its possible but I don’t see any change on any of the switches. The main power can be 12V right?

4

let’s a see a picture of your board wired up. Switches get wired Normally closed.(GND and NC)

The terminal is scrolling after you send the command correct? None of the 6 inputs show any sign of life?

5

12v is fine, I am pretty sure they work off just USB as well.

6

well that did it. I guess juggling the wires did something. I’m back in business. Thanks!

1 Like