It's the little things that save the most time

[azab2c]

@vicious1

a step over that can be significantly faster but usually are set to the slotting speeds.

Yeah, that looks neat. Asked for something similar in EstlCam for the new Miter feature…

@azab2c

To help minimize job run time and keep bits appropriately loaded, is there a way to configure “Miter speed” (separately from bit feedrate) as explicit mm/s and/or a percentage multiplier of the bit’s feedrate, since Miter Step down (DOC) will likely (but not always…) be relatively shallow compared to tool’s regular Depth per pass step down. Consider adding “Miter feedrate” in Miter options dialog, and/or “Edit Tool” dialog.

Just a quick finger to shafter patent trolls… Would be neat to have a method and system for maintaining target bit load by varying feedrate and/or doc and/or spindle rpm given computed density and bulk of material being removed/added. Optical/lidar sensors and/or computation of remaining material modeling maybe used.

#tip_cam_feedrate