V1 Engineering Forum

Getting organized before printing parts

Mostly Printed CNC - MPCNC Advice

vicious1 (Ryan) February 18, 2020, 3:37am 44

Hackaday – 18 Dec 17

DIY Cable Chain Looks Great, Stays Cheap

If you’ve built a 3D printer, CNC, laser cutter, or basically any piece of electrical equipment that moves around, then you’ve run into the problem of securing the bundle of wires that …

Better than a cable chain? Random or Off Topic

If you haven’t already seen the HAD write up, https://hackaday.com/2017/12/17/diy-cable-chain-looks-great-stays-cheap/ The bend radius is a little tight on this one but I am definitely going to the hardware store and having a look for something to try this out myself. To me cable chain is sexy but overkill bulky and dirt traps, best suited for runs of a large number of wires, not one or two. Purely my opinion, I don’t mind them anywhere except the Z axis.

1 Like

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled