gaps in corner pieces -Solved-

Im using 1 inch solid steel as my guide rods, printing with polymaker PC-max polycarbonate. ive done a lot of calibration prints and have adjusted for them and all that jazz. My 1 inch rods fit perfectly in the rail holder, so im not sure what my problem is.


am I assembling wrong? it goes, bottom corner, corner spacer, top corner, and thats it, right?

I dont understand how i could be THIS off when the other pieces seem to fit just fine?

That is exactly how that should look. If there was not a gap there could be no tension.

1 Like

ok, thank god. i was panicking for a bit there! i really love how attentive you are to your forums. It heavily influenced me picking up this project, knowing there was help out there!


thanks so much.

1 Like