I just flashed one. If you use the web installer, fresh wifi install, the installer will pop up a yellow warning to push boot. When you do so it finishes. When it is done is says “Done”. Did it do that?
Then you say,
Why did you change computers? Is this using the web installer or the one from github?
Let’s try two things, first is take it off the jackpot and see if that changes how you flash it. Second once it is flashed load all my files, the yaml and config most importantly.
Sorry this is a new board, and a new issue. So there is going to be a bit of stumbling around here.
I did flash it here and it worked as expected but I do not connect to every single board anymore. The part that is striking me odd is it works with the USB.
Can you post the fluid term stuff again so we can be sure it is not going into STA mode still, maybe the Erase is actually the issue here.
It is on long posts you can actually twist it into place if you want.