Fluid Dial (Fluid NC dial pendant by Bart Dring, using M5 Stack's M5 Dial)

[ahbrown41 (Alex)]

@Britt

uart1:
  txd_pin: gpio.0
  rxd_pin: gpio.4
  rts_pin: NO_PIN
  baud: 115200
  mode: 8N1

uart2:
  txd_pin: gpio.14
  rxd_pin: gpio.13
  rts_pin: NO_PIN
  cts_pin: NO_PIN
  baud: 1000000
  mode: 8N1

uart_channel2:
  uart_num: 2
  report_interval_ms: 75

Thanks @MakerJim @Britt @DougJoseph appreciate the response, I was away so just getting back now. So I was following the guide which shows this wiring like this

Are you saying I should connect to the VMot connector vs the 5v connector? Note I am talking the CYD here not the M5.

Thanks again, I will otherwise try these settings tonight.