ESTLCam: Matching outside radius with inside radius

Software / Firmware
1

Hey, I’ve been milling some pretty pixel-ly stuff lately - You’ll get some photos once it’s all together, it’s kind of exciting…

At the moment. I’ve been adding a 6.35mm fillet to the outside corners in solidworks to match the inside corners, since my end mill is 6.35mm, it works, but it’s pretty time consuming, is there a setting in ESTLCam that I can use to do this automatically?

2

No. There is a button to overcut the corners of the pockets. I’m not remembering the name ATM…

But not the opposite, to overcut the part to round the corners to tool radius.