ESP32 usb-c UART boooting issue MPCNC//Jackpot

[MakerJim]

@NeOdYmS

How do I have write the uart config sections ?

You need to add the UART2 section. I’m going through a build right now and am troubleshooting that as it turns out.

My thread is here:

FluidDial builds for RMRRF

Starting with Doug’s modified pendant enclosure that fits an RJ-45 keystone jack, I set about to wire up the first of my two M5 Dials and figure out how to load firmware and connect them. Here’s a pair of RJ45s, wired with short pigtails, 568B standard colors. [image] I then went and did a git clone of the FluidNC firmware from here: There wasn’t anything particularly difficult there, I opened the project in VSCode with platformio. I did discover that as others have previously mentioned, …