Z axis question

[Speed0verdose (Josh)]

Sorry, I was continuing a thought I had in my other thread. I’ll edit it, so It makes more sense.

Z axis homing - 1 side dropping

I have been having intermittent issues that are becoming more frequent on my LR3 SKR 1.2 Dual End stop build. When homing the z-axis, on the Xmin side it will move up, trigger the end stop and immediately fall down, and then start winding back up, hit the top, and fall back down again. Grub screws are tight.

You can delete this thread, I’ll just watch the thread this was split from. I’m having the same issues with the end stops not triggering.