What is the best material/thing to affect capacitive sensor the most?

[Bigchepin (Gato)]

@martin001 , maybe you can take some ideas from the plasma table shielding. Here are a couple examples.

My MPCNC made in China

Yay! It’s working guys, it’s finally working! Alleluia! So, after a lot of hard work, I finally managed to get the plasma cutter to work properly with the MPCNC. It’s been quite a challenge, but now I’m pretty confident the MPCNC will run quite a bit more reliably. So, what have I done? -Shielded everything I could shield: all the motor wires are shielded. On the motor side, the motor body is attached to the wire shielding using some breaded copper sleeve. Then on the other side, the motor ca…

New multipurpose build in Kansas - Plasma/Router/Laser

Slowly making progress! [IMG_20200330_172244] [IMG_20200406_213314] [IMG_20200423_223819] [IMG_20200424_083844] [IMG_20200425_193508] [IMG_20200503_092516] [IMG_20200504_131941] [IMG_20200504_145550] [IMG_20200504_155211] [IMG_20200504_172734]